Expanders

The Expanders Wizard is used to detect and add the connected expander modules to the system, along with their corresponding inputs, outputs and trouble inputs. You can even use it to program modules that are not physically available yet.

1. Connect any new modules to the RS-485 network.

2. Click Step 2- Auto Detection to continue. The wizard automatically detects and displays new and existing modules.

   Each module is assigned a name automatically. These can be renamed as required for easier identification.

3. Click Step 3- Additional Modules to continue.
4. Review the Existing Modules information. Modules that are being connected to the system for the first time are automatically assigned the next available address. You can change these addresses later in Expanders | Expander Addressing.
5. If required, add additional modules for any hardware that is not yet connected to the network.
6. Click Save and Return to Menu to finish.

Progress is shown as the controller is programmed and the corresponding inputs, outputs and trouble inputs are created. Once complete, you are returned to the Home page.